Guide · Star washers

DIN 6797 or DIN 6798: which lock washer

Both are star washers. They differ in how many teeth they have and how wide the teeth are, and each comes with teeth on the outside, on the inside, or for a countersunk head.

The two standards

DIN 6797 covers toothed lock washers. They have fewer, wider teeth, each twisted out of the plane of the washer so that it bites into the screw head on one side and the part on the other.

DIN 6798 covers serrated lock washers. They have more, finer serrations, so the load is shared over more points of contact. That suits small screw heads, thin sheet and electrical contacts.

The Indian Standard IS 5371 covers multi-tooth lock washers in three types: A externally toothed, B internally toothed and C countersunk. We make to all three standards.

External, internal or countersunk

FormTeethUse it when
DIN form A, IS type AOn the outside edgeThe head is big enough to cover the washer. The teeth sit at the largest radius, so they give the most resistance to turning.
DIN form J, IS type BOn the inside edgeThe teeth must not show beyond the head, for example under cheese-head screws, in counterbores or on visible parts.
DIN 6798 form V, IS type CConical, for countersunk headsThe screw has a countersunk head.

What to put on the drawing

Name the standard, the form, the nominal size and the finish, for example "Lock washer DIN 6798 A 8, phosphated". If the washer also carries an earth connection, say so: we check the tooth form on the profile projector and keep the finish conductive.

Both standards cover the common sizes. For other sizes, thicker sections or other tooth counts, send the drawing: we make customised sizes too.

Request for quotation

Send us the drawing.

We reply with a feasibility note within 2 working days for a part made to a standard, and within 5 working days for a custom part. PDF, DWG and STEP files accepted.

Or email the drawing to inquiry@photoray.co.in.