DIN 5417 · DIN 7993

Snap rings

Snap rings are split rings that spring into a groove on a shaft, in a bore or on the outer ring of a bearing, and hold a bearing, gear or bush in place. We make them to DIN 5417 and DIN 7993, and in any size to your drawing.

Standard sizes
DIN 5417, DIN 7993
Custom sizes
Any size, to your drawing
Section
0.1 to 5.0 mm
Material
Mild steel, carbon spring steel or SS 304 / 316
Finish
Zinc, phosphated or blackened
A rectangular-section snap ring with its open gap at the top, top view.

Sizes

Standard or to your drawing

Standard sizes

Every size in DIN 5417 and DIN 7993

Custom sizes

Any size, to your drawing

We develop any size, thickness or form your drawing needs, from 0.1 to 5.0 mm stock. If it needs new tooling, we make the die in our own tool room and give you the timeline once we have studied your drawing.

Materials and finishes

Materials

Mild steelCarbon spring steel EN 42J (C80)Carbon spring steel EN 9 (C55)Stainless steel SS 304Stainless steel SS 316

Finishes

Zinc plated, yellow trivalent passivationZinc plated, green trivalent passivationPhosphatedBlackened

Other grades and finishes to your drawing. Name them in the RFQ.

How we check it

CharacteristicMethod
Section sMicrometer
Free ØVernier caliper and profile projector
Gap gFeeler gauge
HardnessHardness tester

Inspection frequency follows the control plan agreed for your part. Delivered Cpk of 1.33 or higher on the special and important characteristics marked on your drawing.

By assembly

Used in

The assemblies our snap rings go into. Pick one to see the other parts we make for it.

Questions

What engineers ask us about snap rings

Which snap rings do you make?

Snap rings for the outer-ring groove of rolling bearings to DIN 5417, round-wire snap rings for shafts and bores to DIN 7993, and any size to your drawing. Send the groove diameter, the ring section and the material with the RFQ.

Request for quotation

Send us the drawing.

We reply with a feasibility note within 2 working days for a part made to a standard, and within 5 working days for a custom part. PDF, DWG and STEP files accepted.

Or email the drawing to inquiry@photoray.co.in.