Made to your drawing
Shims
Shims set a gap or a preload in an assembly by their thickness alone, so thickness is the dimension that matters. We stamp them in any size to your drawing, and grind them to ± 0.005 mm thickness where the drawing and the flatness it needs call for it.
- Sizes
- Any size, to your drawing
- Thickness
- 0.1 to 5.0 mm
- Ground thickness
- ± 0.005 mm, where needed
- Material
- Mild steel, carbon spring steel or SS 304 / 316
Sizes
Standard or to your drawing
Custom sizes
Any size, to your drawing
We develop any size, thickness or form your drawing needs, from 0.1 to 5.0 mm stock. If it needs new tooling, we make the die in our own tool room and give you the timeline once we have studied your drawing.
Materials and finishes
Materials
Mild steelCarbon spring steel EN 42J (C80)Carbon spring steel EN 9 (C55)Stainless steel SS 304Stainless steel SS 316
Finishes
Zinc plated, yellow trivalent passivationZinc plated, green trivalent passivationPhosphatedBlackened
Other grades and finishes to your drawing. Name them in the RFQ.
How we check it
| Characteristic | Method |
|---|---|
| Thickness s, four points | Comparator stand, four points per part |
| Inside Ø d1 | Vernier caliper and profile projector |
| Outside Ø d2 | Vernier caliper and profile projector |
| Flatness | Dial gauge |
Inspection frequency follows the control plan agreed for your part. Delivered Cpk of 1.33 or higher on the special and important characteristics marked on your drawing.
By assembly
Used in
The assemblies our shims go into. Pick one to see the other parts we make for it.
Questions
What engineers ask us about shims
Are all your shims ground?
No. We grind a shim when its drawing and the flatness it needs call for it, to ± 0.005 mm on thickness. Other shims are stamped.
How do you measure ground shim thickness?
Per part, at four points, on a comparator stand.
Request for quotation
Send us the drawing.
We reply with a feasibility note within 2 working days for a part made to a standard, and within 5 working days for a custom part. PDF, DWG and STEP files accepted.
Or email the drawing to inquiry@photoray.co.in.

