Guide · Washers

Choosing a washer for a joint that sees vibration

A bolted joint comes loose in one of two ways: it loses clamp load as the surfaces settle, or the nut turns under vibration. Pick the washer for the failure you expect.

Start with the clamp load

The first defence against loosening is enough preload from the bolt, tightened to a controlled torque. No washer rescues a joint that was under-tightened. A washer helps the joint keep the preload it was given.

Plain washers

Standards: DIN 125, ISO 7089, IS 2016.

A plain washer spreads the load of the bolt head or nut over a larger area, so a soft or painted surface does not crush and let the preload drop. It also gives the nut a smooth, even face to turn on, which makes the tightening torque more consistent. It does not lock anything.

Conical spring washers

Standard: DIN 6796.

A conical spring washer is dished. Tightening the bolt flattens it, and it stores that deflection as a spring. When the joint settles, a gasket relaxes or the parts expand and contract with temperature, the washer springs back a little and keeps the clamp load up. This is why they are used on busbar joints, on joints with gaskets or soft materials, and on parts that heat and cool.

Star washers

Standards: DIN 6797, DIN 6798, IS 5371.

A star washer has teeth that bite into the underside of the head and into the surface below, so the nut has to cut its way back before it can turn. The teeth also break through paint and oxide, which is why star washers are used on earth connections. They work best on surfaces softer than the teeth, and they mark the surface.

Wave washers

Standards: DIN 137, DIN 6904.

A wave washer gives a light axial load over a long travel. It takes up end play and preloads bearings, but it is not stiff enough to hold the clamp load of a bolted joint.

Which one to put on the drawing

The jointWasher
Soft, painted or slotted surface under the headPlain washer
Gasket, soft material, or the joint settles over timeConical spring washer
Heats and cools, such as busbars and exhaust partsConical spring washer
Needs an electrical contact through paint or oxideStar washer
Light vibration on a small screwStar washer
End play to take up, or a bearing to preloadWave washer

For a joint that sees heavy sideways vibration, send us the drawing and the load. The answer may be a different washer, a different fastener or a change to the joint itself.

Request for quotation

Send us the drawing.

We reply with a feasibility note within 2 working days for a part made to a standard, and within 5 working days for a custom part. PDF, DWG and STEP files accepted.

Or email the drawing to inquiry@photoray.co.in.