Guide · Circlips

Circlip groove design: what the drawing needs

A circlip is only as strong as the groove it sits in. Most circlip problems we are asked to solve start with the groove, not the ring.

How the standards dimension the groove

DIN 471 (external circlips, on a shaft) and DIN 472 (internal circlips, in a bore) give the ring and its groove together. For each nominal shaft or bore diameter d1 they set:

  • d2, the groove diameter, which sets how deep the ring sits;
  • m, the groove width, a little wider than the ring thickness s so the ring can seat;
  • n, the minimum distance from the groove to the end of the shaft or bore.

An external ring is made with a free inside diameter d3 smaller than the shaft, so it grips the groove. An internal ring is made larger than the bore and presses outwards.

What limits the load

Under axial load, either the ring gives way or the groove does. In a soft shaft or housing the groove usually goes first. Three things decide it:

  • Groove depth. A groove shallower than the standard gives the ring less to bear on.
  • Edge margin n. If the groove is too close to the end, the shoulder behind it shears off.
  • The groove corner on the load side. Keep it sharp and square. A large radius or chamfer there lets the ring roll out under load.

High shaft speeds matter too: an external ring can lift out of its groove as it spins. Tell us the speed if it is high.

What to send with the RFQ

  • Shaft or bore diameter, with its tolerance.
  • Groove diameter, groove width and edge distance, with tolerances.
  • The axial load the ring must hold, and whether it is steady or shock.
  • Shaft speed, if the ring rotates.
  • The material and hardness of the shaft or housing.
  • The finish you need on the ring, and any salt-spray requirement.

We make circlips to DIN 471, DIN 472 and IS 3075, and customised sizes and thicknesses to your drawing. If the groove on the drawing is outside the standard, we say so in the feasibility note.

Request for quotation

Send us the drawing.

We reply with a feasibility note within 2 working days for a part made to a standard, and within 5 working days for a custom part. PDF, DWG and STEP files accepted.

Or email the drawing to inquiry@photoray.co.in.